![]() ![]() It should work just fine for all MK5 Jetta cars up to 2009. I say mostly, because the following OBDII scanner seems to be able to fix the airbag issue due to the fact that those computer bits are probably carry over MK5 electronics. The 2010 Jetta has a MK5 body, but with mostly MK6 electronics inside. The reset an airbag or SRS light, you need to use a diagnostic scanner to clear the codes after you repair. Remove, reset crash data hard codes from your srs control module after airbags deployed via OBD2 George Melnik 95K subscribers Subscribe 215K views 4 years ago In this video I will show you. It reset everything, but the airbag light on the dashboard is most likely stored permanently, hard coded in the cars computer and actively needs to be erased. Srs CodeZurich zr15 obd2 code reader manual. So I knew there was not an actual airbag fault or harness issue, as is also common.ĭisconnecting the battery terminals and touching the negative and positive cables together (battery fully disengaged) for 15 mins to discharge the electronics did not work. Probably while the car was still on, and this tripped the airbag light. ![]() I took apart the dash and pulled some fuses to check them. My stock stereo RCD510 revision AC died, as they all do. I have a 2010 Jetta SE 2.5L and was able to fix the dreaded airbag light issue. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |